Keystone Heddolf M330-1KA RF Keypad PDF Manual

Keystone Heddolf M330-1KA RF Keypad PDF Manual

M330-1KA RF Keypad
The RF Keypad can be used with any gate or garage door opener that uses our M294-k
Or Multi-Code receiver inside the opener. The keypad will transmit one after you enter the correct
numeric code. The keypad will NOT
affect the auto close setting of your gate opener.
The keypad will shut down for approximately 40 seconds if your entry code is not correct within 4 tries.
Safety Note: NEVER install the keypad where a person can touch the gate while activating the keypad.
To program the keypad:

  1. Install 4 AA batteries behind the faceplate. OR if hard-wiring see instructions below.
  2. Open the keypad to change the dip switches:
    1. You will see ten (10) Dip switches, each has 2-position setting (on/off)
    2. Set the dip switches to match that of your receiver, gate, or garage door opener.
  3. Change the Master Code:
    1. Enter the default code

Read More In The Manual:

M330-1KA_352_gates_llc PDF